About the NOC:

Connectivity:

Currently there is a full 2000 mbps (2GiG-E connections) supplying our Data Center. In OC fiber line terms that’s close to 3- OC-12 lines and 1- OC-3 line.

The use of non-blocking gigabit devices throughout the network ensures regional latency of a few milliseconds or less, suitable for the most demanding delay-sensitive traffic. Use of redundant fiber rings ensures network reliability and availability. 

The data center has connections to many different Internet backbones including Level3, Genuity, Time Warner and Yipes. By connecting to multiple tier 1 backbones, the data can be distributed through many sources. This architectural design also means that the network connections are not dependent upon an single Internet backbone.  Thus when probems occur, traffic rerouting is automatic, thereby ensuring the integrity of the network and continued access for our high-speed servers. 

This takes the term “multi-homing” to a whole new level. Presently bandwidth utilization is 5% during peak traffic times. Therefore, the network is very flexible.  If one of the backbone connections experiences problems, the traffic can simply be rerouted over other paths, thereby ensuring that users receive fast access times to sites hosted on our network. 

In addition, the network runs Border Gate Protocol (BGP4). BGP is used at a provider with more than one access point to the Internet. It helps create a truly redundant network. In fact, in an ideal situation, a lease line failure should result in the BGP routing session to close on the bad leased line and the router on a working circuit should then begin to accept the additional traffic. In other words, traffic from a down circuit is redistributed across other circuits, thereby maintaining network integrity. Providers that are multi-homed and correctly setup can actually be more reliable than a single backbone provider because they have multiple paths to multiple providers.

Internal Connectivity

A provider's local area network is not often enough being seen as a point of latency.

The two main sources of latency for a full-time Internet connection are the user's local area network and the Internet provider's local area network. Ether switches and high-end Juniper routers anchor the local network. This top-of-the-line network hardware ensures that data requests get to their destination and back out of the network as fast as possible.

We use ether switches instead of hubs because of their speed and their security capabilities.

Whereas only one computer plugged into a hub can talk at one time, all the machines connected to a switch can talk at the same time.

This means more data can travel through a switch and each server acts as its own node on the network. Furthermore, since each server is its own node on the network, it is difficult for hackers to trace data packets with sensitive information (i.e. passwords) to a particular server.

Servers on the network do not share a single path (T3). Instead, the servers are connected into a high-speed Ethernet switch. This switch is connected to the core router at the data center.

From the core router, data is sent back to the end user across the fastest available path. Whereas statically routing traffic over one path creates a single point of failure, this distributed architecture ensures that users can access data extremely quickly and have multiple paths both into and out of our network.